It is official, this week Lumber Liquidators has finally made the decision to pull all hardwood floors made from China off the shelves and stop selling these potentially toxic products.  Carl Tobias, a University of Richmond Law School professor, said the company’s decision to suspend Chinese laminates should have been done sooner.

Since the 60 Minutes New Story about Lumber Liquidator flooring products containing high levels of formaldehyde, their stock has fallen about 60% and more than 100 class-action suits have been filed against the company.

If you believe you may have wood floors that may have high levels of formaldehyde, you should get the air quality in your home or building tested.

We offer cost-effective and accurate chemical analysis and monitoring ($89.00) of the air quality in your home.

Call us NOW!

(516) 322-8630

Clean Hardwood Floors

One of the most common questions I am asked is, “How to clean hardwood floors?”

1. The first thing you need to to is to determine what kind of finish is on your hard wood floors – SURFACE SEALED FLOOR or PENETRATING SEALED FLOOR.

• Rub your fingers across your wood floor.  If your finger leaves a smudge mark then your floor has a wax finish which is indicative of a Penetrating wood sealed floor.  Typically older wood floors are like this.   A penetrating seal or oil was soaked into the floor and liquid or paste wax was applied afterwards to help seal and protect it.  You need to clean this type of wood floor with care.  Plain soap and water or Murphy’s Oil Soap is a good product to clean this type of wood floor.  But be careful using too much water and towel dry them afterwards to blot up excess moisture.  Once clean, seal these wood floors with wax.
• If you see no smudge when you rub your fingers across your hardwood floor, then your floor is most likely a newer SURFACE SEALED Floor.  Most of these types of hardwood floors were sealed with polyurethane or a polycrylic product.  These types of hardwood floors are  stain and water resistant and the easiest to care for and clean.
• If the floor finish is worn off and you can see the wood, you will need to get the floors refinished.  If you are not sure, try pouring a little water on the floor. If the water is absorbed into the wood then your finish is worn off.  Most likely, the floors will then need to be sanded and covered with a sealer and protective coating (several coats) to get restored back to looking like new. Here below is a photo of a hardwood floor that needed to be refinished.  Notice how you can see the finish is worn off and the wood itself is now dull, dark and embedded with dirt.

These photos show a high traffic area near the front entrance door where the floor finish is worn off.  In the next photo below, you can see the AFTER picture where we refinished the hardwood floors to look like new again.

If you would like your hardwood floors examined by us in person, call Joe at (516) 322-8630  

.